обд-адаптер для consult для работы с LEAF 2011 пруль

LKA · 15.03.2020, 20:07

в родном сервисмане найдено следующее:

Performing the following procedure can automatically activate recommunication of VCM and BCM, but only when the VCM is replaced with a new one*.
*: New one means a virgin VCM that has never been energized on-board.
(In this step, initialization procedure using CONSULT is not necessary)
NOTE:
• When the replaced VCM is not a brand new, the initialization of BCM using CONSULT is necessary.
• If multiple keys are attached to the key holder, separate them before beginning work.
• Distinguish keys with unregistered key IDs from those with registered IDs.

Work Procedure
1. Install VCM.
2. Contact backside of registered Intelligent key* to power switch while brake pedal is depressed, then turn power switch to the ON position.
*: To perform this step, use the key that is used before performing VCM replacement.
3. Maintain power switch in the ON position for at least 5 seconds.
4. Turn power switch to the OFF position.
5. Check that the vehicle can be set to READY.

подскажите плз, как сделать VCM "девственно чистым"?

15.03.2020, 20:07	#27 (permalink)
LKA Новичок Регистрация: 27.02.2020 Сообщений: 48 Вы сказали Спасибо: 20 Поблагодарили 9 раз(а) в 7 сообщениях Сказал(а) Фууу!: 0 Сказали Фууу! 0 раз(а) в 0 сообщениях Откуда: Kurgan Авто: Nissan LEAF	в родном сервисмане найдено следующее: Performing the following procedure can automatically activate recommunication of VCM and BCM, but only when the VCM is replaced with a new one. : New one means a virgin VCM that has never been energized on-board. (In this step, initialization procedure using CONSULT is not necessary) NOTE: • When the replaced VCM is not a brand new, the initialization of BCM using CONSULT is necessary. • If multiple keys are attached to the key holder, separate them before beginning work. • Distinguish keys with unregistered key IDs from those with registered IDs. Work Procedure 1. Install VCM. 2. Contact backside of registered Intelligent key* to power switch while brake pedal is depressed, then turn power switch to the ON position. *: To perform this step, use the key that is used before performing VCM replacement. 3. Maintain power switch in the ON position for at least 5 seconds. 4. Turn power switch to the OFF position. 5. Check that the vehicle can be set to READY. подскажите плз, как сделать VCM "девственно чистым"?