в родном сервисмане найдено следующее:
Performing the following procedure can automatically activate recommunication of VCM and BCM, but only when the VCM is replaced with a new one*.
*: New one means a virgin VCM that has never been energized on-board.
(In this step, initialization procedure using CONSULT is not necessary)
NOTE:
• When the replaced VCM is not a brand new, the initialization of BCM using CONSULT is necessary.
• If multiple keys are attached to the key holder, separate them before beginning work.
• Distinguish keys with unregistered key IDs from those with registered IDs.
Work Procedure
1. Install VCM.
2. Contact backside of registered Intelligent key* to power switch while brake pedal is depressed, then turn power switch to the ON position.
*: To perform this step, use the key that is used before performing VCM replacement.
3. Maintain power switch in the ON position for at least 5 seconds.
4. Turn power switch to the OFF position.
5. Check that the vehicle can be set to READY.
подскажите плз, как сделать VCM "девственно чистым"?
|