ESP это стабилезация движения автомобиля,при выбивание ESP загорается ЭДС,это или датчик под седушкой водителя или не исправность руля(проверить угол поворота руля)

Sheer чем закончилось?

DTC Descriptor
DTC P160D 00: Incorrect Engine Calibration Detected
Circuit/System Description
This diagnostic addresses if the ECM is not programmed with the right engine calibration.

Conditions for Running the DTC
• The ignition is ON.
• The DTC runs continuously once the above condition is met.
Conditions for Setting the DTC
The ECM detects that a wrong engine calibration is programmed in the EEPROM for greater than 1 s.

Action Taken When the DTC Sets
DTC P160D is a Type A DTC.

Conditions for Clearing the DTC
DTC P160D is a Type A DTC.

Нет не закончилось, тема еще актуально, ошибка в моторном :shock:

DTC P160D (LUJ)
Diagnostic Instructions

• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P160D 00: Incorrect Engine Calibration Detected

Circuit/System Description

This diagnostic addresses if the ECM is not programmed with the right engine calibration.

Conditions for Running the DTC

• The ignition is ON.

• The DTC runs continuously once the above condition is met.

Conditions for Setting the DTC

The ECM detects that a wrong engine calibration is programmed in the EEPROM for greater than 1 s.

Action Taken When the DTC Sets

DTC P160D is a Type A DTC.

Conditions for Clearing the DTC

DTC P160D is a Type A DTC.

Reference Information



DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Testing

Program the ECM. If DTC P160D sets after programming, perform the following steps:

• Ensure that all tool connections are secure.

• Ensure the programming equipment is operating correctly.

• Ensure the correct software and the correct calibration is used.

• Attempt to program the K20 Engine Control Module.

⇒ If DTC P160D sets, replace the K20 Engine Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM replacement, setup, and programming.

ну я у себя разобрался (у меня не было р0300)
а вам советую начать с p0300.
Далее поподробней когда и после чего появилась данная проблема?

Катушку всё таки пробовали менять?

При пропусках в первую очередь менять модуль зажигания, а уж потом ВВПровода.

А из за чего вылазит ошибка U0100?

Из-за "потеря связи с блоком
Пост N 1