REPROGRAMMING PROCEDURE
- Replace the suspected injector(s) and establish
communication with the ECM:
• read the data and note the correction value on the
replaced injector(s),
1. Turn ignition switch OFF.
2. Connect CONSULT-II to DLC.
3. Turn ignition switch ON.
4. Input injector correction value(s) using "ENTER
INJCTR CALIB DATA", "WORK SUPPORT" mode
with CONSULT-II.
5. Turn ignition switch OFF.
6. Wait at least 60 seconds.
7. Turn ignition switch ON.
8. Confirm that the replaced number(s) has been
reprogrammed using "ENTER INJCTR CALIB
DATA", "WORK SUPPORT" mode with CONSULTII.
• using the Diagnostic tool ensure that the ECM has
not detected malfunctions related to the injector
codes and check that the instrument panel warning
light is off.
|