прошивать одисом
----------
AC Compressor First Run-In
Necessary when the Climatronic control module (J255) is replaced.
Prerequisites to start the basic setting A/C compressor first run:
Engine at idle
Transmission in Park or Neutral
Do not cycle the ignition
Basic setting was performed for the flaps
Inside blower motor is switched on
Air vents fully open
Load management not active
"AC Compressor First Run-In" Steps:
Start engine and allow it to Idle.
Adapt flap end stops as described above.
[Basic Settings - 04]
Select "Compressor Run In; Automatic Start" from the drop-down list.
It will show completed, but wait 120 sec (2 Min) and observe the flashing A/C button light on the HVAC panel.
After the Basic Settings has completed, the A/C light will quit flashing and the fault code will clear.
|