alex9916

DTC P160D (LUJ)
Diagnostic Instructions

• Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

• Review Strategy Based Diagnosis for an overview of the diagnostic approach.

• Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P160D 00: Incorrect Engine Calibration Detected

Circuit/System Description

This diagnostic addresses if the ECM is not programmed with the right engine calibration.

Conditions for Running the DTC

• The ignition is ON.

• The DTC runs continuously once the above condition is met.

Conditions for Setting the DTC

The ECM detects that a wrong engine calibration is programmed in the EEPROM for greater than 1 s.

Action Taken When the DTC Sets

DTC P160D is a Type A DTC.

Conditions for Clearing the DTC

DTC P160D is a Type A DTC.

Reference Information



DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Testing

Program the ECM. If DTC P160D sets after programming, perform the following steps:

• Ensure that all tool connections are secure.

• Ensure the programming equipment is operating correctly.

• Ensure the correct software and the correct calibration is used.

• Attempt to program the K20 Engine Control Module.

⇒ If DTC P160D sets, replace the K20 Engine Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM replacement, setup, and programming.