ТРЕНИРУЙТЕСЬ
P1CYX
Electrical Steering Column Lock maximum number of unlock/lock retries
Configures the maximum number of retries to unlock/lock the Electrical Steering Column Lock (ESCL) if an error occurs during operation.
P1QCX
ESCL, Front Axle, Speed Threshold
Defines the front axle speed threshold below or equal which the Electrical Steering Column Lock (ESCL) power can be enabled.When set to 0 km/h, this condition is disregarded.
P1IAZ
Electrical Steering Column Lock Overheat Max Activations
This parameter is used in the Electrical Steering Column Lock (ESCL) overheat protection.
It defines the maximum number of actions (locking or unlocking) which can be performed in a time slot without risking overheating the ESCL.
P1FJM
Electrical Steering Column Lock Retry Procedure Timeout Defines the maximum allowed time that a retry procedure should take.
If the Electrical Steering Column Lock (ESCL) does not complete the retry sequence within this time, it is considered an error.
P1EQ6
CIOM HW I/O emulation: ESCL Power Supply output, B:10
Control the output request on ESCL Power Supply output (replace the functional request by diagnostic control value), B:10.
FALSE = deactivate output
TRUE = activate output
P1G20
Electrical Steering Column Lock Locking/Unlocking
Functionality Enabled
This parameter enables the ability to lock and unlock the Electrical Steering Column Lock (ESCL).
The parameter shall be enabled when the cab has been docked to the chassis.
Once enabled, the function can not be disabled using this parameter.FALSE = ESCL
P1BVP
Engine start ESCL status to allow engine crank enable
Defines if the electrical steering column lock (ESCL) status shall be checked as a condition to allow engine crank.
The value should be set to ""True"" when the electrical steering column lock is installed.
FALSE = ESCL status for crank disabled
TRUE = ESC
P1DVX
Electrical steering column lock.startup delay
Configures the maximum allowed time to wait before the ESCL starts sending traffic after it is requested to be powered on.
P1C5I
LIN 7 Connected Slaves Defines the node addresses (NAD's) for all LIN slaves connected to the LIN 7 network.
Array element 0 = NAD for RAINS.Array element 1 = NAD for ESCL.Array element 2 = NAD for PDC_IP.
Array element 3 = NAD for PDC_BB_A.Array element 4 = NAD for PDC_BB_B.Arra
P1A1W
Electrical Steering Column Lock Function
Defines if electrical steering column lock is present on truck and enables diagnostics on output.
IMPORTANT: This parameter is related to the R116 regulation and should not be deactivated when the electrical steering column lock is present on the vehicle.