Замена задних тормозных колодок на А8
 

Поменял задние тормозные колодки на А8, подскажите как убрать ошибку о их износе.

did you use the original sensors?

дело в том, что датчики стоят только на передних колодках. ошибка появилась после замены задних, старые колодки не устраивали тем, что пищали. видимо это связано еще и со стояночным тормозом?

что отображается на панели приборов?
сводили разводили супорта компьютером?
А8 какая? какого года?тип кузова?мы не экстрасенсы.

А8 D3? 2006 года. замену производил с компьютером.
Адрес 53: Стояночный тормоз
01316 - Блок управления тормозов
004 - нет сигнала/связи - Непостоянно
02596 - Изношены задние тормозные накладки
008 - недостоверный сигнал

Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 005
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The brake pads are now opening.
[Done, Go Back]
[Close Controller, Go Back - 06]

Turn ignition off.
как-то так помоему
:smile:

Open Rear Parking Brake for Repairs
Prerequisites:
Connect a battery charger as per repair manual.
Cycle the Parking Brake ON, then OFF first.
[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 007
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The brake pads are now opening.
[Done, Go Back]
[Close Controller, Go Back - 06]
Close Rear Parking Brake
Prerequisites:
Connect a battery charger as per repair manual.
[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 006
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The brake pads are now closing.
[Done, Go Back]
[Close Controller, Go Back - 06]

Close Rear Parking Brake
Prerequisites:
Connect a battery charger as per repair manual.
[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 006
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The brake pads are now closing.
[Done, Go Back]
[Close Controller, Go Back - 06]

Function Test
Prerequisites:
Connect a battery charger as per repair manual.
Cycle the Parking Brake ON, then OFF first.
[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 010
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The brake pads are now opening and closing 3 times.
Wait 30 seconds after the the brakes stop making noise.
[Done, Go Back]
[Close Controller, Go Back - 06]
:smile:

Longitudinal Acceleration Sensor (G251)
Prerequisites:
System voltage at least 12.0 V.
Car parked on a level surface.
Do NOT move/rock car while performing basic setting.
[Select]
[53 - Parking Brake]
[Basic Settings - 04]
Group 020
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The status of the Longitudinal Acceleration Sensor (G251) is now being displayed.
[Done, Go Back]
:super: