FVDI full

Я менял [Ссылки могут видеть только зарегистрированные пользователи. Зарегистрироваться...]

Ребята Какой идет парт-номер пульта на VW Polo 2011-2012 ?:help:

Добрый день.Подскажите пож где можно взять инфу по прописке иммо после замены БУ...ключ один авто Гольф 4 2003г .

Engine Control Unit (ECU) Swapping (USED ECU)

Prerequisites:
The NEW (USED) ECU is installed in the car.
Battery voltage at least 12.5 V.
All relevant coding and adaptation values have been transferred from the OLD (ORIGINAL) ECU to the NEW (USED) ECU.
Make sure to have BOTH PIN's, from the OLD (ORIGINAL) and the NEW (USED) ECU.
Make sure to have the Radio Code (for factory radios only).


[Select]
[01 - Engine]


[Login - 11]
For the following procedure, use the PIN of the NEW (USED) ECU.
There are 2 possibilities how to enter a PIN, choose the one that applies for you.
4-digit PIN
The PIN needs to be entered as 5-digit number. For example, if your PIN is 1234, enter 01234.
7-digit PIN
[Use 7-digit PIN/SKC]
Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
[OK]
VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".

[Do it!]


[Adaptation - 10]
Enter 050 in "Channel Number".
[Read]
For the following procedure, use the PIN of the OLD (ORIGINAL) ECU.
There are 2 possibilities how to enter a PIN, choose the one that applies for you.
4-digit PIN
The PIN needs to be entered as 5-digit number. For example, if your PIN is 1234, enter 01234.
7-digit PIN
[Use 7-digit PIN/SKC]
Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
[OK]
VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".

[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]


Switch OFF the ignition and let the car sit for ~1 minute, then switch ON the ignition again.
Verify that the NEW (USED) ECU now shows the VIN and if supported IMMO-ID of the vehicle now.


Engine Control Unit (ECU) Swapping (NEW ECU)

Prerequisites:
The NEW ECU is already installed in the car.
Battery voltage at least 12.0 V.
All relevant coding and adaptation values have been transferred from the OLD (ORIGINAL) ECU to the NEW ECU.
Make sure to have the PIN of the CAR.


[Select]
[01 - Engine]
[Adaptation - 10]
Enter 050 in "Channel Number".
[Read]
For the following procedure, use the PIN of the CAR.
There are 2 possibilities how to enter a PIN, choose the one that applies for you.
4-digit PIN
The PIN needs to be entered as 5-digit number. For example, if your PIN is 1234, enter 01234.
7-digit PIN
[Use 7-digit PIN/SKC]
Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
[OK]
VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".

[Test]
Check the 1st measuring value.
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

Спасибо. Это можно только VAG com или например можно и WOW проделать? да и если например pin нового ЭБУ не известен тогда как?

Приветствую всех! Подскажите занимался ли кто нибудь установкой дополнительного отопителся на VW POLO 6R HATCH 2011? Схему нашел, куда подключать тоже, вопрос остался открытым по кодировке ЭБУ двигателя, какой байт и бит за это отвечают?
ЭБУ SIMOS10.20H02 SW: 03F 906 070 E HW:03F 906 070 D.

кто может помочь с кодировкой АБС 8.2 6RU 907 379 B front H03 0001
на поло седан.

помогите с прошивкой для акпп туриг 3,2 2003г
блок-02 09D927750A номер детали
AL600 6Q------- 0584
50 0210 версия прошивки
4136 кодировка
это я нашел в самодиогностике тока не понял что куда и если можно объясните пожалуйста как редактировать stt не могу сообразить что куда вписывать
пользуюсь VAC-PC 50
0210 версия прошивки не понимаю что это.
если версия 0584.
и что это AL600 6Q.
или направьте в нужную ветку.

нет обновлений на твою коробку .