|
Диагностика Land Rover / Jaguar | ремонт электроники Обмен опытом в вопросах компьютерной диагностики Land Rover / Jaguar, ремонт ЭБУ. Установка JLR IDS и работа с ним. |
|
LinkBack | Опции темы | Поиск в этой теме | Опции просмотра |
21.01.2023, 07:09 | #1 (permalink) |
Новичок
Регистрация: 27.10.2022
Сообщений: 44
Вы сказали Спасибо: 0
Поблагодарили 2 раз(а) в 2 сообщениях
Сказал(а) Фууу!: 0
Сказали Фууу! 13 раз(а) в 12 сообщениях
Откуда: Waynesboro,MS,United/States
|
How to Connect JLR DoIP VCI Pathfinder Interface
The new JLR approved DoiP VCI is the only unit that will be compatible with Pathfinder and all JLR vehicles with the new vehicle architectures (from the Range Rover/Range Rover Sport (L405/L494) 17MY onwards) or allow the enhanced diagnostics that Pathfinder will offer the retailer.
Part 1: How to Connect Original JLR DoIP VCI via WiFi? Part 2: How to connect JLR DoIP VCI via USB? Part 1: How to Connect Original JLR DoIP VCI via WiFi? Original Jaguar Land Rover diagnostic tool JLR DoIP VCI supports both USB and WiFi connection. Here’s the guide to configure the LAN setting. Procedure: Connect JLR DoIP VCI W-F interface with vehicle Connect the other end of VCI with laptop via USB cable Open VCI Manager (JLR), press Connect Choose Network Setup tab->Wired Etherent Tick Enable Wired Etherent Interface Press Apply button and Yes Then disconnect USB connection Close VCI Manager Open VCI Manager again Press Connect Go to Network Setup->Wired Etherent Press Set Factory Default Press OK if system prompts you are about to reset the VCI communication settings to a factory default state. Enable network connection Press Set Factory Default again In Wireless (802.11), choose Obtain an IP address automatically, then press Access Point Choose Wireless resource which is the same as the your network Press Configure Enter wireless security password (encryption key) Press Next JLR VCI is configured to connect to your network Disconnect and then Connect VCI It shows WiFi connection is done Open JLR SDD software on desktop Press Connect Now you can run SDD software for diagnosis Part 2: How to connect JLR DoIP VCI via USB To setup USB connection, you need to download Bosch driver for VCI first: Open Bosch_Driver folder Open MTS6533_Setup Install Bosch VCI Software (JLR) Press Next Press Next Press Install Finish installing Bosch VCI software USB Configuration in progress. Don’t disconnect JLR VCI from PC until a message indicates that the configuration process has completed. Open Device Manager to check the Bosch JLR DoIP VCI adapter is well connected Open VCI Manager on desktop to make sure the Manager detect JLR VCI which indicates interface is well connected Right click JLR SDD software on desktop->Find File location C:/Program Files/JLR/SDD/Runtime Open the GatewayManager with Notepad Find “Device5 = JLR-DOIP” and change value to “, Device5 = JLR-DOIP” Find Go to C:/Program Files/JLR/IDS/Runtime Open the GatewayManager with Notepad Find “Device5 = JLR-DOIP” and change value to “, Device5 = JLR-DOIP” Setup completed. Now you can run JLR SDD and Pathfinder software If you have any other questions, Email: |
|
|