just english bro

This is the same flash, old and new versions.

GREAT JOB BRO
 

SO MANY THANKS FROM THEBOTTOM OF MY HEART:wave:

good night bros,need flash file for this ecm in english
model 372-2900-00 working on genset c32
part num :21946166JV
& if you may i need the 10 digits factory password for it too
as it shows me error codes for 261-13 engine timing calibration required & the
error 253-02 personality module mismatch
should i re program it or install new ecm ?
& what will happen if i copied the current configuration ? need your help please

Please provide the engine serial number. It is on the plate. It would be best if you posted a photo of all plates (engine and generator set)

Here you are all data

Another info you may need
thanks in Advance
& please provide me the 10 digit password cause i don"t have the Html file right now

The flashfile is a replacement for the file you already have installed. If the ECM worked before, and then these errors appeared, then it is probably faulty and needs to be replaced with a new one. In this case, the firmware will not help.

this ecm is the existing one with these messages wouldnt it help to give it another flash file or should i replace it withnew one ??
I i heared that i should have the 10 digit password to remove that error code from ecm

Passwords cannot be made now, because the engine serial number is incorrect. Equipment no is also incorrect. These numbers can only consist of numbers and English characters. You can try to fix these numbers, but if the ECM is dead, they will be lost again, as will other settings.