CATERPILLAR FLASH FILES

amr saeed

just english bro

Alexandr79

This is the same flash, old and new versions.

Вложения

emcp41.rar (2.63 Мб, 12 просмотров)

amr saeed

SO MANY THANKS FROM THEBOTTOM OF MY HEART

amr saeed

good night bros,need flash file for this ecm in english
model 372-2900-00 working on genset c32
part num :21946166JV
& if you may i need the 10 digits factory password for it too
as it shows me error codes for 261-13 engine timing calibration required & the
error 253-02 personality module mismatch
should i re program it or install new ecm ?
& what will happen if i copied the current configuration ? need your help please

Alexandr79

Please provide the engine serial number. It is on the plate. It would be best if you posted a photo of all plates (engine and generator set)

amr saeed

Here you are all data

Изображения

	Image_20250607084149.jpg (38.0 Кб, 4 просмотров)
	Image_20250607084204.jpg (71.6 Кб, 5 просмотров)
	Image_20250607084214.jpg (49.8 Кб, 5 просмотров)
	Image_20250607084222.jpg (43.0 Кб, 8 просмотров)

amr saeed

Another info you may need
thanks in Advance
& please provide me the 10 digit password cause i don"t have the Html file right now

Изображения

	Image_20250607084604.jpg (70.6 Кб, 6 просмотров)
	Image_20250607084623.jpg (142.3 Кб, 10 просмотров)

Alexandr79

The flashfile is a replacement for the file you already have installed. If the ECM worked before, and then these errors appeared, then it is probably faulty and needs to be replaced with a new one. In this case, the firmware will not help.

Вложения

4764030.rar (633.7 Кб, 2 просмотров)

amr saeed

this ecm is the existing one with these messages wouldnt it help to give it another flash file or should i replace it withnew one ??
I i heared that i should have the 10 digit password to remove that error code from ecm

Alexandr79

Passwords cannot be made now, because the engine serial number is incorrect. Equipment no is also incorrect. These numbers can only consist of numbers and English characters. You can try to fix these numbers, but if the ECM is dead, they will be lost again, as will other settings.