Andros

Hi neptun,

As far as I know, there is an SD out there that could unlock video-in-motion on NTG2.5 but it is based on FIN (factory Identification Number) and cannot be common for all units. But I am searching for this SD even if has not my FIN. Have you ever came across?

Thanks

----------

You can easily create an update cd by cooking the official MB telematic one. All you need to do is to create a new set of CONFIG.CDI and CD_INFO.CDI files according your NTG2.5 part number and place them to the root directory of your new CD. Also the label should be "ALPINE_DVD". In the following example my NTG2.5 is a 1649014400-XXX unit:

[CD-INFO];
CD-NAME 1718274559-0002;

# HU25,HU25_VAN
[1649014400-XXX];
################################################## ##########
# SW_TELEMATIK_BLUETOOTH_E53_31
0019025100-001 \HU25\092200\A001902\5100_001\;
# SW_TELEMATIK_GATEWAY_HIGH_E53_31
0019025300-001 \HU25\092900\A001902\5300_001\;
# SW_TELEMATIK_NAVI_HIGH_ECE_E53_4
0019025600-001 \HU25\093000\A001902\5600_001\;
# SW_TELEMATIK_AVC_HIGH_ECE_USA_E53_31
0019025900-001 \HU25\092900\A001902\5900_001\;


[CD-CONFIG];
CD-NAME 1718274559-0002;

[DOFLASH];
# Hardware from Harman/Becker
[1649014400-XXX] 0019025300-001;
[1649014400-XXX] 0019025900-001;
[1649014400-XXX] 0019025100-001;
[1649014400-XXX] 0019025600-001;

Of course make sure that the directories of each firmware (described in CD_INFO.CDI) exists and contains the appropriate firmware files (.BIN) including the original SEQUENCE.SCR and SECURITY.DEF

Then, just burn your new cooked CD and put it in your NTG2.5. Go to Engineering menu (HANG + 6 + *) and then SW Update menu. Normally if everything is ok, the Detail and Start button will be activated. By pressing start, keep in your mind that you need about 35 minutes to complete your flash.

Enjoy all :)